News

[PM25-1][Firmware Update] Version 25.08.15.A Adds Push Interval Control, PM2.5 Status Display, and Forced Internal Fan Cleaning

[PM25-1]User Guide Documentation Update, Advanced Firmware Tool Release, Basic YAML Source Code Release

[PM25-1] End of pre-order phase, all sensors for the first batch of adventurers sent out, good luck!

[PM25-1] [Scenario Test] Near a humidifier, two freshly assembled PM25-1 readings performed, very closely.

[Usage Scenario] PM25-1 No significant increase in particulate matter detected in the vicinity of the 3D printer

PM25-1 housing optimized, white final housing, about to be shipped assembled after the next 72 hours of testing the components.

[Pre-Order][First Batch]Particulate Matter Sensor PM25-1 For HomeAssistant By Screek (SPS30 + ESP32-C3 + ESPHome)

PM25-1 Shell Design Completed, Inviting Adventures Soon!

PM25-1 Daily Observation, with a maximum detection rate of once per second, is quite responsive.

PM Sensor PM25-1 is coming, internal tests satisfactory, quiet and interesting dust sensor.Based on the Swiss SPS30 sensor.